[esp-r] Problem with CFD model

[Gian Luca Brunetti]

Dear colleagues,
I am trying to make a specific model including a CFD domain work, but I am not succeeding and I cannot find the problem.
This is a link to the zipped model:

https://polimi365-my.sharepoint.com/:u:/g/personal/10026736_polimi_it/EXEPZrwXGIBMmFZRUGC5uEcBaJEhCeby-xdoRZOYuu9LAw?e=xNQ81I

The model has three zones and the network of each is disconnected from the others.
The CFD domain belongs to the short zone sandwiched between the other two. When that zone is modelled as a nodal network, the simulation runs, but when I switch to the CFD modelling, it doesn't. I have tried several routes without success.
I would greatly appreciate any advice.
Thank you in advance and in any case.
Best regards
Gian Luca


Gian Luca Brunetti
Politecnico di Milano
DAStU- Department of Architecture and Urban Studies / Dipartimento di Architettura e Studi Urbani
via Bonardi 3, building 12
20133 Milano
tel. (+39) 02 2399 5750
cell. (+39) 335 8040808
email: gianluca.brunetti at polimi.it