[esp-r] Re: Blind / Shutter Controls etc.

[Achim Geissler]

Hi Dimitris

for the switching of TMC type "windows" you do not use the "optics control". You need to go in the menu "construction materials", choose the zone of interest and then choose "transparent layer properties". Then you are confronted with the choices you probably remember. The setup is not part of the .ctl file but part of the .tmc file.

Best
Achim


On Oct 7, 2010, at 5:18 PM, Dimitris Mantas wrote:

> Hi All,
>  
> I 'am trying to locate where I can impose blind/shutter controls.
> (e.g switching the optics of windows when radiation, temp or other is above a value).
>  
> I 've tried the optics controls but can't figure out what data to input.
>  
> First, I put a sensor, sensoring radiation on a surface but the program reports back it's going to sense db temp (instead of radiation) on that surface.
> Then the actuator is set to actuate the values for the construction chosen (e.g. double, low e glaz.), however I am not asked what the switched values should be
> (as it was done in previous esp-r versions).
> In in the third menu (period) can't really understand what kind of input is required by the program
> (bidirectional ?? and values such as -30, 1 etc.).
>  
> Could you please give me a hint of what to do ?
>  
> I suppose same querries may emerge for the case of lighting controls etc.
>  
> Searched the cookbook but couldn't find my answers.
>  
> thanx in advance,
>  
> Dimitris
>  
>  
> _______________________________________________
> esp-r mailing list
> esp-r at lists.strath.ac.uk
> http://lists.strath.ac.uk/mailman/listinfo/esp-r

achim.geissler at intergga.ch




-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.strath.ac.uk/archives/esp-r/attachments/20101007/68c8470e/attachment.html