[esp-r] phase change materials

[Arianna Sdei]

Dear All,

I am trying to use phase change materials, phase change plasterboard, via the active components. I am using a melting temperature of 26°C and a solidification temperature of 27°C. I am not sure about the solidification temperature and I would like to know if some of you can advise on this. I am trying to have the PCM exposed, so I always position it on the internal layer as I suppose when the software asks for the position it starts counting the existing layers from the exterior.

However I try, I can't see any substantial reduction in the indoor temperature during a hot summer month. Can any of you give some advice on how to reduce the indoor temperature further by changing the parameters?

Thank you in advance,

Best regards,

Arianna

Arianna Sdei

Research Fellow IFORE (Innovation For Renewal)

UNIVERSITY OF BRIGHTON

Moulsecoomb, Lewes Road, Brighton, BN2 4AT

mobile: 0044 (0)7981739024



___________________________________________________________
This email has been scanned by MessageLabs' Email Security
System on behalf of the University of Brighton.
For more information see http://www.brighton.ac.uk/is/spam/
___________________________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.strath.ac.uk/archives/esp-r/attachments/20140910/ff9ee186/attachment.html