[esp-r] Re: Heat exchanger & Desiccant

[wakana-m at ec.hokudai.ac.jp]

Dear Achim,

Thank you for your advice.
I could make heat exchanger model.
Then I'd like to try to making desiccant cooling model.
Where is the "wet surface" material in ESP-r?
And if we use "wet surface", what can we do ?

Best regards,

Wakana Matsumoto

----- Original Message -----
> Dear Wakana,
> 
> there was a discussion on heat exchangers very recently. Look for "
Adding HRV to model" in the archive.
> 
> I am not sure if ESP-r has a desiccant wheel module. However, it does 
have a special material "wet surface", so you may be able to set up a 
good model.
> 
> Best
> Achim
> 
> 
> 
> On Dec 17, 2013, at 12:00 PM, wakana-m at ec.hokudai.ac.jp wrote:
> 
> > Dear everyone,
> > 
> > Hello.
> > I'd like to simulate the building including heat exchanger.
> > However I don't know how to make heat exchanger model.
> > Could you tell me the making way ?
> > In addition, I also want to make desiccant cooling system module.
> > Is Esp-r including desiccant wheel module?
> > We would really appreciate your advice.
> > 
> > Best regards,
> > 
> > Wakana Matsumoto
> > 
> > 
> > 
> > _______________________________________________
> > esp-r mailing list
> > esp-r at lists.strath.ac.uk
> > http://lists.strath.ac.uk/mailman/listinfo/esp-r
> > 
> 
> achim.geissler at intergga.ch
> 
> 
> 
> 
> 
> _______________________________________________
> esp-r mailing list
> esp-r at lists.strath.ac.uk
> http://lists.strath.ac.uk/mailman/listinfo/esp-r
>