[esp-r] Re: Thermochromic glazing

[Geissler Achim]

Dear George

are you prepared to do your own coding? It would likely then be easiest (without having checked this, however) to include your own option for CFC control. This control is set up along the lines of the other controls as opposed to the limited and "different" tmc control.

Best
Achim



> -----Ursprüngliche Nachricht-----
> Von: esp-r-bounces at lists.strath.ac.uk [mailto:esp-r-
> bounces at lists.strath.ac.uk] Im Auftrag von George Giannakidis
> Gesendet: Dienstag, 8. Mai 2012 23:10
> An: esp-r at lists.strath.ac.uk
> Betreff: [esp-r] Thermochromic glazing
> 
> Dear All,
> I am trying to model a thermochromic glazing:
> 
> I tried the "Special Components", "Active Materials" option but the
> "thermocromic glazing" component gives the message "No components
> found in this category " and I cannot proceed further.
> 
> I tried to use the "transparent layer properties" in "construction materials" in
> the zone composition definition, but the only available controls are the zone
> temperature, ambient temp., time, incident radiation, lux level and Ltswitch,
> and not the external surface temperature for the window, which I would
> prefer.
> 
> I would appreciate any suggestions on alternative approaches for this
> modeling.
> 
> Best Regards,
> 
> George Giannakidis
> 
> 
> 
> _______________________________________________
> esp-r mailing list
> esp-r at lists.strath.ac.uk
> http://lists.strath.ac.uk/mailman/listinfo/esp-r