[esp-r] Re: sensing temperature of PV cell in example model

[Achim Geissler]

Hi Mark

 

the outside surface of a MLC is node1, each layer has 3 nodes. Where two
layers touch, only one node is defined. So node3 is the boundary between
3mm low iron glass and EVA and node4 should give you the centre-of-EVA-
layer temperature (assuming you gave the layer setup from outside to
inside).

 

Be sure to choose the correct run-mode so that layer temperatures are
written to res (don’t know if 3 or 4 off the top of my head) or use xml-
output.

 

Regards

Achim

 

 

From: esp-r-bounces at lists.strath.ac.uk [mailto:esp-r-
bounces at lists.strath.ac.uk] On Behalf Of ???
Sent: Dienstag, 16. Februar 2010 07:35
To: esp-r at lists.strath.ac.uk
Subject: [esp-r] sensing temperature of PV cell in example model

 

Hi all

 

I'm trying to sense temperature of PV cell, using example model

 

in a category technical features > with photovoltaic-integrated facade.

 

PV_constr consists of 3mm low-iron glass + 3mm EVA + 3mm low-iron glass +
20mm air gap + 4mm grey coted aluminum + 80mm glass fibre quilt + 4mm grey
coted aluminum.

 

According to a diagram that I got, it seems that PV cell is located btw
layer 1and 2. (3mm low-iron glass and 3mm EVA)

 

In this case, what layer should I sense in order to find out temperature
difference of PV cell?

 

Your comments will be appreciated. Thank you in advance.

 

Regards

 

Mark Kim

 

 


-- 
Researcher,
Integrated Simulation Team, DASS consultants Ltd.

632-9 Guui 1(il)-dong Gwangjin-gu Seoul (143-834 Korea) 
T. 82.2.913.2585/ F. 82.2.949.2585/ H. www.dasskorea.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.strath.ac.uk/archives/esp-r/attachments/20100216/d5e815e3/attachment.html