[esp-r] Re: inclined overhang

[Achim Geissler]

Dear Marco

as far as I know, this is not possible. However, you can stack smaller  
obstructions diagonally. This should enable you to model your shading  
to a good enough accuracy.

Regards
Achim


On Jan 9, 2009, at 8:20 PM, Marco Manzan wrote:

> hi to all
>
> I would like to simulate a room with an external shading device made
> of an inclined overhang. In esp-r I can add an obstacle and then run
> ish to perform  shading and insolation analysis.  But the obstructions
> are made of prisms that can be rotated along the vertical axis only.
> How can I introduce an obstruction rotated along an horizontal axis ?
>
> thanks in advance
>
> -- 
>  _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
> |Marco Manzan               Email: manzan at units.it            |
> |Tel:   (+39) 040 5583506   Fax  : (+39) 040  572033          |
> |Dipartimento di Ingegneria Navale, del Mare e per l'Ambiente |
> |Universita' degli Studi di Trieste                           |
> |piazzale Europa 1, 34127 TRIESTE                             |
> |_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _|
>
> ----------------------------------------------------------------
> This message was sent using IMP, the Internet Messaging Program.
>
>
>
> _______________________________________________
> esp-r mailing list
> esp-r at lists.strath.ac.uk
> http://lists.strath.ac.uk/mailman/listinfo/esp-r
>

achim.geissler at intergga.ch